Temperature Tower Step Calculator

A temperature tower is a calibration print used to find the optimal printing temperature for a filament spool. It is a tall vertical print divided into sections — each section is printed at a slightly different temperature. After printing, you inspect each section visually (looking for stringing, layer adhesion, bridging quality, and surface finish) to choose the best temperature.

How the calculation works: The tower starts at a high temperature and steps down (or up) by a fixed amount per section. The number of sections is: (Start Temp − End Temp) ÷ Step Size. Each section needs to be tall enough to be useful — typically 5–10 mm per section is standard.

Variables:

• Start Temperature — the hottest section, printed first (top of the tower in most slicer scripts)
• End Temperature — the coolest section, printed last
• Step Size — how many °C to drop between each section (typically 5°C)
• Section Height — how many mm tall each section is (5 mm is a common minimum)

Typical temperature ranges by material:

• PLA: 180–220°C — start at 220, step down to 180
• PETG: 220–250°C — start at 250, step down to 220
• ABS: 220–250°C — start at 250, step down to 220
• TPU: 210–240°C — start at 240, step down to 210
• ASA: 230–260°C — start at 260, step down to 230

Tips for reading results:

• Look for clean bridges with no sagging
• Minimal stringing between points
• Good layer adhesion (no delamination when flexed)
• Glossy, consistent surface texture

Run this calculator to find out how many sections your tower will have, the total print height, and the temperature at each layer change height so you can set up your slicer’s change-at-height script correctly.